CyberPower RMCARD202 Bedienungsanleitung

User’s Manual Network Management Card RMCARD202 Intelligent Network Management Card allows a UPS system to be managed, monitored, and configured

CyberPower Network Management System 8 WEB INTERFACE Login Account There are two user account types. - Administrator (default username : cyber ;

CyberPower Network Management System 9 [UPS->status] Displays basic information about the current UPS status, and the items that are auto refresh

CyberPower Network Management System 10 [UPS->Master Switch] Switches the output power of the UPS to be on or off. Items Definition Reboot UPS

CyberPower Network Management System 11 Passed: The battery performed normally during the test. None: The UPS has never performed the battery

CyberPower Network Management System 12 [Logs->Event Logs] Displays a list of events along with a date and time stamp, and a brief description

CyberPower Network Management System 13 Using NTP server: Enter the IP address/domain name of NTP servers, choose the time zone, and set the frequen

CyberPower Network Management System 14 [System->Shutdown] Items Definition Clients Shutdown Delay The Longest shutdown delay time required fo

CyberPower Network Management System 15 RESET [System->FTP service] Allows you to enable/disable the FTP server service and configure the TCP/IP

CyberPower Network Management System 16 7. Place the jumper back onto the Reset pins. 8. Install card into the expansion port again. 9. Tighten the

CyberPower Network Management System 17 Trouble Shooting Problem Solution Unable to configure the Management Card by method1 or method2 1.Check th

CyberPower Network Management System 2 TABLE OF CONTENTS Introduction………………………………………………………………………1 Installation Guide………………………………………………………………..3 Web

CyberPower Network Management System 18 Appendix 1 IP Address Settings for the CyberPower Network Management Card Overview All devices on a compute

CyberPower Network Management System 19 If the response is shown as below, the IP address is in use. Try another IP address until an available addr

1 INTRODUCTION Overview The CyberPower Network Management Card allows for remote monitoring and control of a UPS attached to a network. After instal

CyberPower Network Management System 2 Application: Unpacking Inspect the Network Management Card upon receipt. The package should

CyberPower Network Management System 3 INSTALLATION GUIDE Step 1. Hardware Installation Internal smart slot network management card (RMCARD202) 1

CyberPower Network Management System 4 Definitions for LED Indicators Link LED color Condition Off The Network Management Card is not

CyberPower Network Management System 5 Figure 1. The main window of the “Power Device Network Utility” program. 4. Select the SNMP card yo

CyberPower Network Management System 6 8. If IP address is successfully set, you will see a message that the IP set up is OK, as shown in Figure 4.

CyberPower Network Management System 7 Method 2: Using a command prompt 1. Obtain the MAC address from the label on the Network Management Card rear